Tensorgrip® P307 is a multi-purpose contact adhesive that effectively bonds a vast range of substrates while maintaining compliance with stringent California VOC requirements (SCAQMD Rule 1168). Tensorgrip® P307 is aggressive and versatile, lending itself to bonding flexible and porous materials with ease.

Key Features: Tensorgrip P307 Multi Purpose Contact Adhesive - 21.9oz

High Tack
Excellent high coverage
650ml = 21.98 oz aerosol can
80% of final strength achieved immediately
Full strength achieved in 24 hours
Fast drying with long open time
Low VOC California Compliant (SCAQMD Rule 1168)
Excellent green strength and high heat resistance
Over 220°F (105°C) temperature resistant
Also bonds: veneers, cork, fiberglass and many
plastics
Excellent bonding to porous substrates
Aggressive – adheres to nearly any surface
Good heat resistance (up to 180°F/82°C)
High-strength, long-term bond
Strong initial bond

DIRECTIONS FOR USE

TensorGrip P307 is designed as a portable, self contained spray system for field or shop applications.
Apply adhesive to both surfaces to be mated, at 80% to 100% coverage.
Allow enough time (2-4 minutes or until dry to the touch) for the adhesive to become tacky before bonding.
Parts should be mated with as much pressure as practical.
Normal coverage required with web spray pattern is approximately 80%; however, porous surfaces may need a second coat. Initial bond is strong enough to allow cutting or trimming immediately, although ultimate strength is achieved in 1-3 days.
Canister system will spray adequately above 60º F. Canister system should be kept in warm area. In the event that the canister gets abnormally chilled, freezes or gives poor or sputtering spray, it should be warmed up before continued usage. Warming canister by immersion in warm water is recommended.
Notice!!! Do not store at temperatures over 120º F.

Canister Storage/Changeover

If you choose to leave the hose and spray gun on the canister, leave the valve on the canister open. Do not disconnect the hose/gun from the canister. Close and lock the spray gun.
To change or disconnect canister: turn canister valve to the off position, spray out remaining adhesive left in the hose, disconnect the spray hose and gun from the canister.
Reconnect the spray hose to a new canister of adhesive. OR if you are NOT connecting to a new canister, connect hose to canister of cleaning solvent (sold separately) and spray out until liquid is clear which indicates that the hose and gun is clean.

Chemical Technical Data

Total Solids: 32-38%
VOC Content: 35.9% by weight (Aerosol) / 45 g/L (Canister)(not available)
Color: Clear or Red
Flammability: Non-Flammable adhesive; Flammable propellant
Solvent: Methylene Chloride
Dry time: 2-4 mins dependent on temp & humidity
Open time: Long
Shelf Life: 18 months from date of manufacture
21.9 oz. can

!!This item cannot ship USPS!!

Documents: Tensorgrip P307 High Temp General Contact Adhesive

Tensorgrip P307 Technical Data Sheet

Fabric and Foam Adhesive